Bars / knitting elements: Individual needle bar and tongue bar, stitch comb bar, knockover comb bar, 2 ground guide bars，2 group Jacquard bars（4 jacquard bars）

Warp beam support: Six warp beam positions for sectional beams of 21-inch and 32-inch flange diameter

GrandStar®(GrandStar COMMAND SYSTEM) :Operator interface to configure, control and adjust the electronic functionality of the machine

Yarn Iet-off device:For each completely mounted warp beam position: one electronically controlled yarn Iet-off drive

Fabric take-up: Electronically regulated fabric take-up, driven by geared motor, consisting of four rollers.

Batching device: Separate rolling device, maximum rolling diameter 1270mm (50”)

Pattern drive

• Electronic guide bar drive EL, all guide bars shog up to 50 mm
• Optional for 130-inch increased shog distance (up to): 150 mm

Electrical equipment

• Speed-regulated drive, total connected load of the machine: 7.5 KW
• Voltage: 380V±10% three-phase power supply, main power cord requirements: not less than 4m㎡ three-phase four-core power cord, ground wire not less than 6m㎡

Oil supply

• Heating and cooling by means of circulating air heat exchanger, filter with dirt-monitoring system
• Optional: Heat exchanger for water conditioning plants

Equipment working conditions

• Temperature 25℃±3℃, humidity 65%±10%
• Floor pressure: 2000-4000KG/㎡

Working width: 136 inch

Gauge: E18、E24

Knitting Speed

• Maximum knitting speed: 700-900 courses/minute
• Inching knitting speed: 20 courses/minute