Working width & Gauge

• Type: Compound needles
• Gauge: E6, E9, E12, E14, E16, E18, E24
• Width：181″  188“ 220″  230“ 275″

Bars / knitting elements: Single-needle bar, knockover comb bar and slider bar, stitch comb bar, 6 ground guide bars, or 2 pattern bars and 4 ground guide bars.

GB1 to GB4 stitch-forming

Yarn Feeding Systems：

• WARP BEAM SUPPORT: warp beam positions, free-standing, for working from sectional beams with a flange diameter of 812 mm (32”) Yarn let-off device electronically controlled, driven by geared motor.
• YARN FEEDING DEVICES: 3 or 4 yarn feeding device positions with 3 driven feeding rollers each, for working from a creel
• FTL: Film cutting and stretching device for working with primary film

GrandStar®(GrandStar COMMAND SYSTEM) : Operator interface to configure, control and adjust the electronic functionality of the machine

Integrated monitoring systems: Integrated Laserstop

Yarn Iet-off device: For each completely mounted warp beam position: one electronically controlled yarn Iet-off drive

Fabric take-up: Electronically regulated, system with friction drive, driven servomotor, controlled via Motion Control.

Batching device: Separate floor-standing cloth rolling device

Pattern drive: Electronic guide bar drive EL

Electrical equipment:

• Speed-regulated drive, total connected load of the machine: 25 kVA
• Voltage: 380V±10% three-phase power supply, main power cord requirements: not less than 4m㎡ three-phase four-core power cord, ground wire not less than 6m㎡

Oil supply: oil/water heat Exchanger

Equipment working conditions:

• Temperature 25℃±6℃, humidity 65%±10%
• Floor pressure: 2000-4000KG/㎡