Working width & Gauge

• Type: Compound needles
• Gauge: E24 E28 E32
• Width：130”170”

Bars / knitting elements: Individual needle bar and tongue bar, stitch comb bar, knockover comb bar, six ground guide bars

Warp beam support: Six warp beam positions for sectional beams, two of 32-inch flange diameter for the beam positions 1 and 2 and four of 21-inch flange diameter for the beam positions 3 to 6

GrandStar®(GrandStar COMMAND SYSTEM): Operator interface to configure, control and adjust the electronic functionality of the machine

Integrated monitoring systems: Integrated Laserstop

Yarn Iet-off device: For each completely mounted warp beam position: one electronically controlled yarn Iet-off drive

Fabric take-up: Electronically regulated, system with friction drive, driven servomotor, controlled via Motion Control.

Batching device: Separate floor-standing cloth rolling device

Pattern drive

• Electronic guide bar drive EL, all guide bars shog up to 50 mm
• Optional for 130-inch increased shog distance (up to): 150 mm

Electrical equipment

• Speed-regulated drive, total connected load of the machine: 25 kVA
• Voltage: 380V±10% three-phase power supply, main power cord requirements: not less than 4m㎡ three-phase four-core power cord, ground wire not less than 6m㎡

Oil supply: oil/water heat Exchanger

Equipment working conditions

• Temperature 25℃±6℃, humidity 65%±10%
• Floor pressure: 2000-4000KG/㎡