Technical data：

Working width & Gauge

• Type: Latch needles (the needle can be mounted on bed in block or inserting separately)
• Gauge: E1, E3, E6, E8, E10, E12
• Width：181″, 205″, 268″, 283″, 335″, 413″, 503″

Bars / knitting elements：

• Single-needle bar, knockover comb bar and slider bar, stitch comb bar
• Bars Number: 6 (Other type can be: 2, 3, 4, 5, 6, 8)

Yarn Feeding Systems：

• WARP BEAM SUPPORT : 4 warp beam positions, free-standing, for working from sectional beams with a flange diameter of 812 mm (32”) Yarn let-off device electronically controlled, driven by geared motor.
• YARN FEEDING DEVICES: 3 or 4 yarn feeding device positions with 3 driven feeding rollers each, for working from a creel
• FTL: Film cutting and stretching device for working with primary film

GrandStar®(GrandStar COMMAND SYSTEM): Operator interface to configure, control and adjust the electronic functionality of the machine

Integrated monitoring systems: Integrated Laserstop

Yarn Iet-off device: Mechanical negative Let-off gear.

Fabric take-up: Mechanical regulated, system with friction drive, driven servomotor, controlled via Motion Control.

Batching device: Separate floor-standing cloth rolling device

Pattern drive: n-drive with 6 pattern discs, integrated tempi change gear.

Electrical equipment

• Speed-regulated drive, total connected load of the machine: 25 kVA
• Voltage: 380V±10% three-phase power supply, main power cord requirements: not less than 4m㎡ three-phase four-core power cord, ground wire not less than 6m㎡

Oil supply: None

Equipment working conditions

• Temperature 25℃±6℃, humidity 65%±10%
• Floor pressure: 2000-4000KG/㎡